Let’s simply follow the steps:
First of all information related to BIOS: -
Well! BIOS passwords are used to add some extra security to computers when it boots up. You can either set a password to prevent access to BIOS settings or to prevent PC from booting by going to BIOS Settings by pressing F2 or F8 in Intel Machines. But sometimes this extra security might become painful when you forget the BIOS password or someone changes your system BIOS password intentionally. But there is no need to worry about. There are many known ways to reset / remove / bypass the password:
Now First Method is by removing CMOS Battery from the Mother Board as you see below Image.
As you see this is CMOS Battery now follow these instructions carefully…..
Almost all motherboards use a small coin sized CMOS battery to store all BIOS settings along with the password in chips and this battery supply some current to keep the small settings for BIOS inside the chips just like our Digital Watch or Calculator for storage purpose. Now, to reset the password, unplug the PC, open the cabinet and remove the CMOS battery for approx. 15-30 minutes and then put it back. It'll reset all BIOS settings as well as the password and you'll need to re-enter all settings. If it fails, then try to remove the battery for at least one hour.
Don't worry if it’s not working I Am here Buddy just comment below and I will help you out!!!!
Another Option is:-
By Using the Motherboard Jumper: In most motherboards CMOS battery is soldered, which makes it difficult to remove the battery. In this case we use another method. Almost all motherboards contain a jumper that can clear all CMOS settings along with the BIOS password. The location of this jumper varies depending upon the motherboard brand. You should read your motherboard manual to check its location. If you don't have the manual then look for the jumpers near the CMOS battery. Most of the manufacturer labels the jumper as CLR, CLEAR, CLEAR CMOS, etc. When you find the jumper, look carefully. There will be 3 pins and the jumper will be joining the center pin to either left or right pin. What you need to do, is remove the jumper and join the center pin to the opposite pin. e.g. if the jumper joins center pin to left pin, then remove it and join center pin to right pin. Now wait for a few seconds and then again remove the jumper and join the center pin to left pin. Make sure to turn the PC off before opening the cabinet and resetting the jumper.
All is from Vishal please leave Comments if you like my information